broncobowsher
Contributor
As much as I would like to not have the 2 batteries in the transmitters, I think I still prefer the data on the NERD and not the Controller.
Welcome to ScubaBoard, the world's largest scuba diving community. Registration is not required to read the forums, but we encourage you to join. Joining has its benefits and enables you to participate in the discussions.
Benefits of registering include
As much as I would like to not have the 2 batteries in the transmitters, I think I still prefer the data on the NERD and not the Controller.
While we are diverging from modification into the dreamland of how it would be nice if rEvo built it this way...The beauty of DiveCAN (or any CAN bus for that matter) is that the sensors write to the bus and anything monitoring that bus (whether it be a controller or a monitor) can display that information.
Anyway, as @stuartv said, it's not a reason to choose one CCR over another, but it's certainly a very nice feature that I wish other CCRs utilized. rEvo doesn't use a "head" so I'm not sure what that implementation would look like, however.
Where would the high pressure transducer be mounted? The only feeds into any box are low pressure. Thus you’d need TWO wired transducers with DiveCAN interfaces that are waterproof and can be plugged into the bus. How much are those five pin DiveCAN connectors?While we are diverging from modification into the dreamland of how it would be nice if rEvo built it this way...
Adding hardwired pressure transducers shouldn't be difficult. I imagine it would be very much like the input from the RMS.
There is a bit more to it. I always open my unit and dry the cover, lungs, and squeeze the loop so that by the time I need to fan things out, moisture content is minimal. Also, I dry my units inside so circulation assists evaporation.
I am currently working on a prototype for portable drying. My main goal is to dry the unit as effectively as possible at a hotel room so that I can do back-to-back dive days with the driest possible counterlung & loop combo. I set the temp to 70F which kicks in AC and dries out the air in the room. The challenge is to increase circulation and inject dry air in. I tried with the cover on and w/o the cover - the results were inconclusive because my setup was less than optimal.
@lermontov - your setup is nice, as you have quick disconnect or bayonet attachments. I'll DM you.
Will keep you posted.
Hey Kris, the revo dries fine in front of a fan without anything else. Make sure to shake the water out of the loop and leave the cover off. Now tell us in the ccr travel thread all about Indonesia CCR support!Many greetings from Indonesia. I am diving my rEvo around a couple of months now in Indonesia and I would be very interested to hear about your drying setup you mentioned in a post here.
Any recommendations are most welcome as I am quite new to the rEvo and try to treat it as best as possible .
Many many many greetings from Wakatobi
Kris
I tried multiple setups. Wipe your lungs with a towel dipped in disinfectant. Dry in front of a fan. This is the most straight forward setup that is easy to do in the field. I don't bother drying the loop, as I rinse it twice with disinfectant and whatever moisture stays in the loop, dries out.Many greetings from Indonesia. I am diving my rEvo around a couple of months now in Indonesia and I would be very interested to hear about your drying setup you mentioned in a post here.
Any recommendations are most welcome as I am quite new to the rEvo and try to treat it as best as possible .
Many many many greetings from Wakatobi
Kris