drk5036
Contributor
I don't buy this explanation.Any air bladder you have on your back will, when inflated, push your face forward. That's just a fact. Sort of like, a law of nature. That said, you shouldn't have to inflate any bladders very much at the surface, because you should be very close to neutrally buoyant, and only need a bit of additional air to keep your face above the water. It's when you are overweighted that you need to blow those bladders up to compensate, and that's when something on your back will pitch you forward. Lots of instructors do overweight students, because it's easier to make sure they'll go down, and then just use their BC like an elevator. But that's poor diving. On the surface you add a little air to keep your face out of the water, but you should not need to blow air in until the exhaust valve pops open.
The "pitching forward" motion is due to torque. This torque develops from there being a distance between where buoyancy is pushing up and where your center of mass is. Since the wing is on your back, it will develop a slight forward torquing motion, but this torque will be small if only a small amount of air is added. Furthermore, assuming you aren't significantly overweighted, the effect will be exactly the same in a jacket BCD. You'd have to put a ton of air into the BCD for the belly area to fill with air. If you have a small amount of air in the BCD, the water pressure will make sure it goes to the top, where it will...act exactly the same as the wing. The only way to counteract this would be to fill the whole 50 lbs bladder with air, then you would have air providing buoyancy from directly below your center of mass.
As someone who has used a backplate for the last 100 dives or so, I've NEVER noticed this effect. I wonder if it could be that I usually have about 2 kg placed on the cam-bands? This would result in my center of mass being pushed behind my backplate, potentially within the wing, which would stop the torque?