- Messages
- 97,344
- Reaction score
- 98,332
- Location
- On the Fun Side of Trump's Wall
- # of dives
- 2500 - 4999
falling off a motorbike is 100% avoidable...
going OOA IS avoidable but it happens - wasn't it some other guy talking about burst disks and popped o-rings?
Burst disks and o-rings are unlikely to go during a dive unless they're already defective ... in which case you should have caught it during a routine bubble check.
Think about it ... as you continue the dive, the pressure in your cylinder is putting less and less stress on those parts. A burst disk will typically blow during the fill process, or if you leave your cylinder in a place where it heats up (even in warm water, it'll cool down once you submerge it). And an o-ring will typically blow when you initially apply pressure to your regulator ... or at a minimum, it'll allow a tiny stream of air to release, which is easily detectable either by listening or by checking the tank valve before starting the dive.
Same logic applies to hoses ... they don't just blow, they will give you some amount of "warning" first.
That why bubble checks are a standard part of our pre-dive routine.
... Bob (Grateful Diver)