Scubapro G250 can't be serviced??

Please register or login

Welcome to ScubaBoard, the world's largest scuba diving community. Registration is not required to read the forums, but we encourage you to join. Joining has its benefits and enables you to participate in the discussions.

Benefits of registering include

  • Ability to post and comment on topics and discussions.
  • A Free photo gallery to share your dive photos with the world.
  • You can make this box go away

Joining is quick and easy. Log in or Register now!

So, I switched balance chambers to see what the difference in minimum cracking effort was (knob fully out position). The difference in base height as measured by @Open Ocean Diver was 0.024"/0.6mm. That's less than a half turn on the knob. I started with the old style, shorter base chamber and a cracking effort of 1.05". Sure enough, when I put the taller base balance chamber in my G250, the min cracking effort went from 1.05" to 1.12" measured with the precision cracking effort pump. It all makes sense, if not really significant. On the other hand, I'd rather be able to get 1" min on my G250 than 1.1", so there's that.

As for which balance chamber clears the wiper o-ring, here's a picture:
20210405_095703.jpg

As you can see, in my reg, there's 79.5mm clearance from the knife edge of the orifice to the locking pin hole in the barrel.
When the pieces are set out at that distance with the old balance chamber, the wiper o-ring is just inside the crown, and thus performing its function. More surprising is the amount of compression on that poppet spring. It's fully 1/3 compressed in its least compressed position.

My conclusion? For the G250 at least, it doesn't matter which balance chamber you use, unless you want below spec cracking effort (which I do :D).
One of these days I'll take a look at the G260...
 
the min cracking effort went from 1.05" to 1.12"

Was the lower cracking effort achieved with the newer/longer balanced chamber or with the older/shorter balance chamber?
 
Was the lower cracking effort achieved with the newer/longer balanced chamber or with the older/shorter balance chamber?
Lower cracking effort with the old (shorter) balance chamber. Poppet spring less compressed. I edited my post for clarity.
 
but if the base height dimension is the same, it makes no difference....

upload_2021-4-5_13-56-13.png


The "stem" length is irrelevant....

right?

Were your bases different heights?
 
but if the base height dimension is the same, it makes no difference....

View attachment 651934

The "stem" length is irrelevant....

right?

Were your bases different heights?
That's the way I see it. Shorter base = less spring compression.
 
Yes, that is true.

That picture gave me pause there was a difference...
 
Even with the longer BC with IP135 both my G250V crack at .7, .8” can’t tune them to 1” without a spring shim. :banghead:
 
https://www.shearwater.com/products/swift/

Back
Top Bottom