sandmanz32
Contributor
aeris atomis bcd ( love the bc but im saving up for a bp/w), only complaint with this bc is that its hard to keep perfect trim.
scubapro mk25 first stage, with a g250v 2nd, and a r235 octo, attached to a hp steel 130 cylinder. (absolutely love these regs! you will have to pry them from my cold, dead hands!)
suunto cobra 2 with integrated compass (still use the wrist mounted compass more than the POS electronic one, only complaint about the cpu)
i normally use a uk ck8 dive light with an aqualung as a backup.
as far as personal gear goes, i usually use a haylcon mask, scubapro jet fins, and no snorkel (dont see the point).
exposure protection used would be; pinnacle elastiprine 5mm with merino lining, henderson 5mm hood, henderson 2mm gloves(gotta keep dexterity), and 5mm scubapro hard sole boots.
i love all of my current equipment. it all seems to do what its supposed to. the only real issue i have is using the compass on the cobra 2 and getting correctly trimmed out with that bcd. i can get perfectly horizontal, but as soon as i kick i go to 45 degrees. to correct that ill be going with a oms steel backplate, hog harness (1-piece), oxycheq 30# wing, and a total of 4 small oms weight pockets. 2 will be on the front of the "cumberbun" of the harness, and 1 will be on either side of my tank.
scubapro mk25 first stage, with a g250v 2nd, and a r235 octo, attached to a hp steel 130 cylinder. (absolutely love these regs! you will have to pry them from my cold, dead hands!)
suunto cobra 2 with integrated compass (still use the wrist mounted compass more than the POS electronic one, only complaint about the cpu)
i normally use a uk ck8 dive light with an aqualung as a backup.
as far as personal gear goes, i usually use a haylcon mask, scubapro jet fins, and no snorkel (dont see the point).
exposure protection used would be; pinnacle elastiprine 5mm with merino lining, henderson 5mm hood, henderson 2mm gloves(gotta keep dexterity), and 5mm scubapro hard sole boots.
i love all of my current equipment. it all seems to do what its supposed to. the only real issue i have is using the compass on the cobra 2 and getting correctly trimmed out with that bcd. i can get perfectly horizontal, but as soon as i kick i go to 45 degrees. to correct that ill be going with a oms steel backplate, hog harness (1-piece), oxycheq 30# wing, and a total of 4 small oms weight pockets. 2 will be on the front of the "cumberbun" of the harness, and 1 will be on either side of my tank.