That's what I did when my BCD failed to hold air on a 130' wall dive.
Apparently the pull dump got snagged or somebody manhandled it on the boat. It was working that morning, but when I added some air around 65' to slow my ascent it bubbled back out and my descent sped up again. Only after repeating this cycle again did I fin to stop and check things out. I found that the pull dump was stuck open. Inspection after the dive revealed that the pull dump wire cable was broken and stuck beneath the dump valve, thereby holding it open.
Although I was negatively buoyant it was well within the range of my control, so I went ahead and went down the wall of Molokini to 130' to look at the shark condo. I did find it more convenient to then ascend to up around 50-60' where, with a full full lung, I was almost up to neutral buoyancy. Had I really needed to I could have stayed at 130', although it would have been enough work that the dive wouldn't have been enjoyable.
This was with a 5mm full wetsuit. Someone with two layers of 7mm would have to work a lot harder. Someone just wearing a 3mm shorty or other thin wetsuit would find it really easy.
It's pretty easy to do a drill to see how difficult it would be for you to have a BCD failure --- simply empty all of the air out of your BCD while at depth with a nearly full tank and see how hard it is to hover and ascend.
Charlie Allen