I thought the same thing was possible for a VR3. I thought that is was possible for a VR3 to give a message "use tables". I think that computer was designed for techdiving.
How do you know something like that can't happen by Shearwaters,Ratio, Divesoft, OSTC, etc. ? ;-)
I'm not sure why you are trying to lay the burden of proof at tbone1004's door, since all the manuals are most likely available online. But as it happens, a VR3 doesn't abandon you. Here's what the manual says:
"Should a microbubble stop be missed, a “Use tables” message will appear. The
decompression schedule displayed thereafter, although very close to the requiredNo
duration, may be in error. If this occurs consult backup tables and add additional stops
or stop time as required. While continued diving with the VR is possible, the
decompression displayed may not be exact. “Use tables” will show for 24 hours."
A "microbubble stop" is a deep stop imposed atop Buhlmann ZHL16. So when this message is displayed, you are essentially falling back to Buhlmann. Things could be worse (grin).
A Shearwater Petrel or Perdix will not lock out, either.
I happen to own all three, but if you're curious about others I'm sure you can find out about them.
Being bits of electronic kit, computers can of course fail. When that happens all bets are off. This is why a lot of thinking divers have two of them. (In fact, I have not lately dived with anyone who happens to use only one.) If you have one and it malfunctions invisibly it's certainly a good thing if you have some clue about what it ought to be saying. If you have two and one fails, it would be a good thing if you knew which it was. For these cases, some alternative strategy that allows you to figure out somewhat reasonable stops knowing only depth and time (assuming you do) is worthwhile. That can be +/- printed tables, RD, or a buddy who's been next to you the whole time showing you a working one, or handing you a backup.