1" latex is way too big, going to order 3/4" but probably not for a week.
Question Stationary Magnahelic Tester needed to service regs?
- Thread starter NYCrecdiver
- Start date
Please register or login
Welcome to ScubaBoard, the world's largest scuba diving community. Registration is not required to read the forums, but we encourage you to join. Joining has its benefits and enables you to participate in the discussions.
Benefits of registering include
- Ability to post and comment on topics and discussions.
- A Free photo gallery to share your dive photos with the world.
- You can make this box go away
1" latex is way too big, going to order 3/4" but probably not for a week.
Did you get 1" ID or OD? Mine is about 1"OD so it could be 3/4" ID.
ETA:
I checked through my Amazon archives and it is 1" OD, 1/8" wall, 3/4" ID. The listing is no longer valid though.
Most of the time I can stuff that into a mounted mouthpiece for a quick oral check without having to pull it apart. For use with the vacuum pump, the seal needs to be really good due to the low flow rate and that means pulling the mouthpiece and stretching the latex over the mouthpiece barrel on the 2nd stage body.
Should do it. Maybe see my addition above...
Would silicone work Amazon has that in 3/4 ID
$14.00 delivered probably less than shipping from McMaster.
Y'all are trying to DIY one of these, right? Mouthpiece Adapter Assembly, Acetal. For $25, you get the mouthpiece adapter with the barbed fitting and the latex band seals. I can understand if you're buying 3-feet of latex or silicone tubing to make several of these assemblies, but if you're only making a single unit I would think ordering it from Scubatools is not that much more expensive than DIY.
Similar threads
