OP
BigRed96
Contributor
I bought the piston oring tool from Herman as well this morning as well as the pin spanner.
Scubapro MK10 service tools
- Thread starter BigRed96
- Start date
Please register or login
Welcome to ScubaBoard, the world's largest scuba diving community. Registration is not required to read the forums, but we encourage you to join. Joining has its benefits and enables you to participate in the discussions.
Benefits of registering include
- Ability to post and comment on topics and discussions.
- A Free photo gallery to share your dive photos with the world.
- You can make this box go away
- Messages
- 17,617
- Reaction score
- 9,880
- Location
- Somewhere between here and there
- # of dives
- 2500 - 4999
An adjustable wrench will take care of the yoke nut. In a pinch a cut hose will work as a first stage holding tool.
While you're ordering from Herman, get one of his 1 inch sockets. An adjustable wrench may work, but you can also mangle the yoke retainer if someone else has over torqued it. Herman also make a regulator handle to thread into the regulator. Alternatively, remove a high pressure plug (or the hose) and a low pressure port plug (or hose) and carry your reg to the hardware store get one each bolt that will screw into the ports to use as handles.
Similar threads
