Hi, I've been struggling with my octo on each dive because it always hangs.
I've tried the several octo holders and I was never satisfied.
First, the yellow cap. Too bad.
Difficult to put inside.
Then with the hose clip. The hose keeps running and the octo hanging.
Then threading the octo hose go and back in a BCD D ring. I haven't the courage to bend the hose so much.
Finally I've seen a silly solution :
Octo Holder Clip @ Divers-Supply.com
And it's so silly that I decided to do it myself, not because it's expensive, which is not, but for the pleasure to do it by myself.
This is the result :
and working in the attach.
I only had to buy the o-ring.
The size of the o-ring is :
Diameter : 40 mm
Toroid diameter : 3 mm
The textile ribbon is :
Wide : 3 cm
Long : 27 cm
The clip and the ribbon were taken from an old bag. The cost of the o-ring 25 cents.
I've tried the several octo holders and I was never satisfied.
First, the yellow cap. Too bad.
Difficult to put inside.
Then with the hose clip. The hose keeps running and the octo hanging.
Then threading the octo hose go and back in a BCD D ring. I haven't the courage to bend the hose so much.
Finally I've seen a silly solution :
Octo Holder Clip @ Divers-Supply.com
And it's so silly that I decided to do it myself, not because it's expensive, which is not, but for the pleasure to do it by myself.
This is the result :
and working in the attach.
I only had to buy the o-ring.
The size of the o-ring is :
Diameter : 40 mm
Toroid diameter : 3 mm
The textile ribbon is :
Wide : 3 cm
Long : 27 cm
The clip and the ribbon were taken from an old bag. The cost of the o-ring 25 cents.
Attachments
Last edited: