Mares Mr42T

[mvergalito]

I have a Mares Mr42T (proton Metal). I am going to buy the scuba wrench tool to replace the Yoke with the Din. What size is the nut on the Yoke? Is is a 1 inch or 26 mm?

thanks, Mark

 

[BodenseeDiver]

because mares ital. Company is, have metrical system, I would say 26 mm

 

[LeadTurn_SD]

I'm away from home for a day, but I can check the exact size tomorrow evening (I have both the 1" and 26mm sockets) if you don't get better responce. My recollection is that it is the 26mm that I used on my Mares MR-22's and MR-12's.

I you are buying the socket from scubatools, I'd also recommend the 3" x 3/8" drive extension.

3" x 3/8 Drive Extension

Best wishes.

 

[mvergalito]

thanks guys, i still can't find any definitive answer on the size. It would make perfect sense that it should be the 26mm, but i could swear that a dive shop told me one time that it was the 1 inch. I would hate to order the wrong size. So if anyone could confirm it, that would be great.

Much appreciated. Mark

 

[coralcruiser]

thanks guys, i still can't find any definitive answer on the size. It would make perfect sense that it should be the 26mm, but i could swear that a dive shop told me one time that it was the 1 inch. I would hate to order the wrong size. So if anyone could confirm it, that would be great.

Much appreciated. Mark

Why don't you just post the question on their forum here... I'm sure Zach will respond.