calabash digger
Contributor
Thanks in advance...
G260 TUNE IS THIS THE CORRECT WAY?
- Thread starter calabash digger
- Start date
Please register or login
Welcome to ScubaBoard, the world's largest scuba diving community. Registration is not required to read the forums, but we encourage you to join. Joining has its benefits and enables you to participate in the discussions.
Benefits of registering include
- Ability to post and comment on topics and discussions.
- A Free photo gallery to share your dive photos with the world.
- You can make this box go away
Half right, you can/should do this end with the cover off so you can see where the lever is. It does look to be about where it should be.
The fine tune is more on the other end, under that black plug in the adjustment knob, if the lever is close you loosen the font tuner screw until you get some leaking, turn it in until it stops and turn it in a little bit more, this is all done with the knob all of the way out.
Purging while adjusting the in-line protects the seat, the knob end is spring pressure adjustment so no purging needed.
The fine tune is more on the other end, under that black plug in the adjustment knob, if the lever is close you loosen the font tuner screw until you get some leaking, turn it in until it stops and turn it in a little bit more, this is all done with the knob all of the way out.
Purging while adjusting the in-line protects the seat, the knob end is spring pressure adjustment so no purging needed.
- Messages
- 17,268
- Reaction score
- 9,470
- Location
- Somewhere between here and there
- # of dives
- 2500 - 4999
DM me your email address and I'll send you the manual.
- Messages
- 17,268
- Reaction score
- 9,470
- Location
- Somewhere between here and there
- # of dives
- 2500 - 4999
To add:
Every time you adjust micro adjuster you need to re check lever height and adjust orifice accordingly. Back it off to leak then back in to just stop the leak. Rinse and repeat.
Every time you adjust micro adjuster you need to re check lever height and adjust orifice accordingly. Back it off to leak then back in to just stop the leak. Rinse and repeat.
- Messages
- 17,268
- Reaction score
- 9,470
- Location
- Somewhere between here and there
- # of dives
- 2500 - 4999
I didn't watch video.
OP
calabash digger
Contributor
I set you a DM. Thanks to everyone I am trying to educate myself..
- Messages
- 17,268
- Reaction score
- 9,470
- Location
- Somewhere between here and there
- # of dives
- 2500 - 4999
Sent some files.
Similar threads
