Converting Sitech Shoulder Dump to Cuff Dump – Tips Needed

[ZenHscuba]

It’s good you’ve decided on a configuration. Let us know if you still have the same setup in a year’s time.

Of course! I might be modifying it again by then.

 

[Edward3c]

Of course! I might be modifying it again by then.

As your in Japan you might be interested in BSAC Japan.

 

[ZenHscuba]

I’m curious about what divers in other countries think.

I’m looking for detailed instructions on how to install a Si Tech valve port. Do you know how to do it?

 

[ZenHscuba]

In any event, just close the shoulder dump all the way and put a separate low profile dump in the wrist, if you don’t like it, take it out and seal it up and you still have the shoulder valve.
If you you get comfortable, take the shoulder valve out.

Do you know a good way to seal the hole if I want to remove the shoulder dump valve and the port?
My drysuit is a D7X NyloTech.

 

[FF / EMT]

Do you know a good way to seal the hole if I want to remove the shoulder dump valve and the port?
My drysuit is a D7X NyloTech.

I would imagine a Aquaseal, but I don’t know for sure.
See if the manufacture has a suit repair kit or if they can send you some material, cut it to the side you need, glue it and go diving.

 

[Zef]

I’m curious about what divers in other countries think.

Really? Are you?
You comment quoted above is inconsistent with your comment quoted here below:

I’m totally convinced the cuff dump is the best spot!

How can you be "totally convinced" and still need "detailed instructions" on how to make the modification in your suit you are looking to make?:

I’m looking for detailed instructions on how to install a Si Tech valve port. Do you know how to do it?

SMH
-Z

 

[ZenHscuba]

I’ll contact the manufacturer.
Thanks a lot.

 

[MarkA]

I’ll contact the manufacturer.
Thanks a lot.

I sent that suit in the photo back to the manufacturer when I had the inlet valve moved to the middle of the chest. The same with zip, neck seal, boots replacements.

 

[ZenHscuba]

I sent that suit in the photo back to the manufacturer when I had the inlet valve moved to the middle of the chest. The same with zip, neck seal, boots replacements.

Got it.
Thank you!