For Sale Any interest in non splined G250 jam nuts?

[davehicks]

Any chance of this rolling again? I would take 10 or so for G250/v and R395 if they fit.

How about a Spline Wrench you can makes as many copies of as you need?

ScubaPro Spline Wrench - Open and closed ends Remixed by awkward_swine MakerWorld: Download Free 3D Models

Boost MeHelp support my 3D Printing habit with a Boost! It's greatly appreciated. Several ScubaPro 2nd stage regulators include a “spline nut” on the regulator body. The spine design is supposed to with temperature regulation, but it also makes it difficult to remove or replace without...

makerworld.com

 

[Kahuna.]

How about a Spline Wrench you can makes as many copies of as you need?

I have one, it just doesn't clear the nut on non-SP hoses so I use pliers. I would prefer to just be rid of them.

 

[davehicks]

I have one, it just doesn't clear the nut on non-SP hoses so I use pliers. I would prefer to just be rid of them.

That's why I made this one. And it can be printed scaled up by a few % if it doesn't fit.

 

[Kahuna.]

Looks awesome but buying a printer, learning how to use it, testing fit, learning how to scale and then reprinting seems seems harder than nagging @buddhasummer and @Open Ocean Diver into selling their nuts.

 

[davehicks]

Looks awesome but buying a printer, learning how to use it, testing fit, learning how to scale and then reprinting seems seems harder than nagging @buddhasummer and @Open Ocean Diver into selling their nuts.

Lots of public libraries have 3d printers these days. It is quite easy for a downloaded print like this.

 

[tridacna]

Looks awesome but buying a printer, learning how to use it, testing fit, learning how to scale and then reprinting seems seems harder than nagging @buddhasummer and @Open Ocean Diver into selling their nuts.

Cost me $1 to print at my local library. Super simple. I just submitted the .stl file and voila!

 

[Toasterking]

Any chance of this rolling again? I would take 10 or so for G250/v and R395 if they fit.

I would happily go for for at least 2 of the G250s.

 

[randini]

Isn't the G250 the same as the haclyon halo? Is the jam nut the same size? If so, you can get H hex headed jam nuts from scubadelphia and probably any other H dealer.

 

[Kahuna.]

I did that and received a nut for each of the Halo and Aura yesterday. The aura nut looks like the best replacement on a G250. It has a small section where there is no hex which is not present on the G250 splined nut and probably seats inside a washer but I am thinking I will run it backwards.

The Halo nut has the "built-in" washer or "flats" and looks like a better replacement for the G250v. But I havent had time to try it yet.

When I can get to it I will also be trying them on the R395 but from the outside the Aura nut looks a better match.

 

[tridacna]

How about a Spline Wrench you can makes as many copies of as you need?

ScubaPro Spline Wrench - Open and closed ends Remixed by awkward_swine MakerWorld: Download Free 3D Models

Boost MeHelp support my 3D Printing habit with a Boost! It's greatly appreciated. Several ScubaPro 2nd stage regulators include a “spline nut” on the regulator body. The spine design is supposed to with temperature regulation, but it also makes it difficult to remove or replace without...

makerworld.com

View attachment 891797

How many % do you recommend upscaling? This one is definitely too small.