2nd stage barrel corrosion

[Mobulai]

Ok will do again although ive looked..

But 2.5yrs from last overhaul

Under a microscope/ jewelers loupe?

 

[LanceRiley]

Under a microscope/ jewelers loupe?

Helmet magnifier?

 

[Mobulai]

That works

 

[LanceRiley]

anyway…. assembled it today. tuned it up.
breathes well… no leaks so far

 

[happy-diver]

So get a stick cut a slot wrap some wet and dry through it and spin it on a cordless until the brass gleams

Rebuild the thing and clean it as you usually do, forever


Better than a bought one!

 

[LanceRiley]

So get a stick cut a slot wrap some wet and dry through it and spin it on a drill until the brass gleams

Rebuild the thing and clean it as you usually do, forever


Better than a bought one

hmmm this sounds like a good idea. i was gona ask this….

i was thinking of… Gun Barrel brass brush or Snake Bore lol

 

[Nemrod]

Not at home now. What is the ID of the air barrel?

 

[Mobulai]

The TX50 knob oring (when installed) has an OD of approx 10.3-10.4mm, so.. somewhere there

 

[LanceRiley]

The TX50 knob oring (when installed) has an OD of approx 10.3-10.4mm, so.. somewhere there

sounds like a 10mm or 0.40 caliber bore snake

 

[Nemrod]

sounds like a 10mm or 0.40 caliber bore snake

I was thinking a Flexi-hone.

But the Happy Diver solution is a good one. Split a dowel, double fold a piece of 600 paper for a flapper, glue it in the split with a drop of super glue, spin it with a drill motor working back and forth.