Gone for diving
Contributor
Check out this link,
scubaboard.com
I bend the ss around the tanks, use steel threaded rod and not SS when pulling everything into position for the first time....
I make a reinforce plate (1/8 -1/4 thick it's in my drawings)
that goes over the overlap and the other side and weld it to the band... welding is best. But if you can't do it some guys just leave it loose and the holes keep everything together... remember the spacers are very important with this design, I use PVC electrical conduit...
Older OMS Manifold Manual
Good day all. I searched here and all over the internets for a manual. I'm rebuilding this as I kept getting leaks. I can't tell if these allen heads are reverse threads or not, maybe they have loctite on them, and maybe it could be some salt in there? You can see the outer o rings were really...
I bend the ss around the tanks, use steel threaded rod and not SS when pulling everything into position for the first time....
I make a reinforce plate (1/8 -1/4 thick it's in my drawings)
that goes over the overlap and the other side and weld it to the band... welding is best. But if you can't do it some guys just leave it loose and the holes keep everything together... remember the spacers are very important with this design, I use PVC electrical conduit...