Where Can I Get PB-300 Glue in Quart?

[oldpeanut]

Recently I just installed a pair of Si Tech Permanent Cuff Rings on a drysuit using PB-300 glue. I found out PB-300 was very good for doing the job. My next project will be to install Si Tech Neck Tite Ring on the drysuit and I need more glue.

A tube of 4 ounce PB-300 cost me Cad$42 including handling, shipping and tax. I just wonder where can I get a quart of PB-300 in the Seattle area where I may just drive from Vancouver and buy it in person. Thanks for any information.

Cheers,

Terry

 

[divad]

...

Copyright © 2013. O.S. Systems, Inc. All Rights Reserved.​

..........................

 

[Peter_C]

Oregon is close to Seattle, or at least as close as you are going to find PB-300.
O.S. Systems

Dive Right In Scuba sells their own version too.

MEK is the thinner for it, as a quart will start drying out over time.

A small seal of Aquaseal should be put around the edge to completely seal the water out. Cotol 240 is the thinner for that, and should be used to thin it down for penetration and make it dry quicker.