Shortening a LP inflator hose

[diversteve]

It hardly seems worth adding two potential failure points for a shorter inflator hose you can get for $22 new at DGX

 

[northernone]

I haven't needed to use one yet, but these inflator hose shortener/adaptors seem quite straightforward... just cut off to correct length and rejoin!
AP Diving LP 3/8 Male Inflator/Regulator Hose Shortener - The Scuba Doctor Dive Shop
View attachment 488782

I have a couple of these, they work flawlessly as they should.

 

[scubafanatic]

While I question the cost/benefit ratio of your project, well, everyone needs a hobby!

 

[Brilig]

Thanks for all the good ideas.
Yes, the cost benifit ratio always messes up any DIY project.
I'm just trying to nurse my old BCD along until I can retire it and try backplate wing so even $20 bucks I look at as $20 bucks further away from a new setup.

 

[rhwestfall]

I'd venture to guess you could find a pretty inexpensive used replacement....

 

[tridacna]

Has anyone shortened a low pressure inflator hose by chopping out a section in the middle and splicing the ends back together? I know it's not a very expensive item and I would normally just go buy the correct length hose but in this particular instance I'm in the mood to cheap out. Besides, I love a good DIY project. So, has anyone got experience they'd like to share?

Exactly what length are you looking for?

 

[Brilig]

Exactly what length are you looking for?

I'll have to measure it to see. I had not priced a new one. Sounds like they are less expensive than I thought.

 

[northernone]

I'll have to measure it to see. I had not priced a new one. Sounds like they are less expensive than I thought.

Here's some in unknown condition for five bucks each. For Sale - Used LP inflator hoses

 

[divad]

Yes, a splice is bulky.

What might I be missing?

Some flexibility?

 

[divad]

I'll give you one, if you pay for shipping. I have several in lengths I will probably never use.What's the length?