Replacing a sheath.

[CT-Rich]

I found a rather nice Promate dive knife last summer and was thinking I might give it to my daughter if I can find a new sheath for it. I figure there must be thousands of sheaths floating around since so many of the knives sink. Any ideas?

 

[g1138]

Can you dig up the model or size?
If it's short enough you can make a Dalton Safety Sheath or DIR [friction] sheath.

 

[CT-Rich]

It is either the Promate sharp pointed 5 3/8" or the Cressi Skorpion knife, which look virtually identical.
Cressi Skorpion Knife at LeisurePro

 

[g1138]

You could possibly get by with a Friction sheath.
You would just need 2ft Nylon webbing and neoprene Cement.

Is the hilt under 2in width?

http://www.scubaboard.com/forums/do-yourself-diy/410676-al-handle-dalton-safety-knife-2.html
See post #19