napDiver
Contributor
I planned using an XDeep stealth 2.0 tec wing and if I needed redundancy a Deco Sidemount Bladder as backup. However, I won't be getting the XDeep wing in time for my trip. So I got two Deco Sidemount Bladders for the time being.
I need recommendations/ideas on how to mount both of them. I have a custom harness I'm currently making. This will be warm water (70-75 F degrees) - 3 mm wetsuit, 2 tank AL80.
The link below is the picture of the wing.
https://www.diveequipmentco.com/med...bef69cfacb880e7c51d402958/s/m/sm3_400x400.jpg
My idea at the moment is to tie the wings at the right, left, and middle bottom grommet holes. The sides would use bungee or quick links. The middle bottom would just be a bungee that goes through both and meets at the front crotch strap / belt buckle. Also it will be attached mainly to me via side bungees with a bungee tie (ie. Sidemount Bungee Tie , Piranha Dive Shop |)
Thanks any critiques or recommendations would be much appreciated.
I need recommendations/ideas on how to mount both of them. I have a custom harness I'm currently making. This will be warm water (70-75 F degrees) - 3 mm wetsuit, 2 tank AL80.
The link below is the picture of the wing.
https://www.diveequipmentco.com/med...bef69cfacb880e7c51d402958/s/m/sm3_400x400.jpg
My idea at the moment is to tie the wings at the right, left, and middle bottom grommet holes. The sides would use bungee or quick links. The middle bottom would just be a bungee that goes through both and meets at the front crotch strap / belt buckle. Also it will be attached mainly to me via side bungees with a bungee tie (ie. Sidemount Bungee Tie , Piranha Dive Shop |)
Thanks any critiques or recommendations would be much appreciated.