Need ball mount for Peregrine TX

[Unaware6905]

Would anyone with 3D modelling experience like a little project? I want a 3D-printed mount for a Shearwater Peregrine that attaches to the back utilizing the strap screws and has an underwater camera 1" ball mount coming out from it. I think the ball mount would be best coming out from behind, but from underneath is fine, too. It could be something similar to this: Ball Mount for Shearwater Teric. I realize the mount would have to be removed to charge the computer. Anyone interested?

 

[Unaware6905]

I found this that might made modeling the attachment to the computer easier: Shearwater Peregrine strap mount.

 

[d^2b]

Any reason you don't just bungee mount it to an arm? That works pretty well for me.

D

Post in thread 'harness mount for shearwater peregrine'

Apr 21, 2024

I decided to mount it to my camera tray, since that gets more gentle treatment than my harness, plus I'm looking at it all the time anyway. Slid some inner tube over one of the arms and did a "cross-over" with the included bungie. I should maybe do one more knot (so it takes 3 failures to fall off), but it seems pretty solid.

• d^2b

 

[Unaware6905]

Any reason you don't just bungee mount it to an arm? That works pretty well for me.

D

Post in thread 'harness mount for shearwater peregrine'

Apr 21, 2024

I decided to mount it to my camera tray, since that gets more gentle treatment than my harness, plus I'm looking at it all the time anyway. Slid some inner tube over one of the arms and did a "cross-over" with the included bungie. I should maybe do one more knot (so it takes 3 failures to fall off), but it seems pretty solid.

• d^2b

I have had my computers like that. However, I want it to stay in one stable position in front of me. On an arm that I have to move for objects at different distances, the computer would change position, too. Just looking for alternatives. I may end up leaving it on an arm in the end.