MK10 tool.

[Packhorse]

Has anyone got a MK10 alignment tool I could get some measurements off. I would like to machine one up on the lathe.

 

[halocline]

I have a tool that's for the MK15, and supposedly one side of it is useful for installing the HP o-ring on MK10s. I've never used it for that. If nobody comes forward with the actual MK10 tool, I can give you measurements of the one I have.

 

[Zung]

It's fully documented here, with drawings, just 1 post below yours

 

[Zung]

Would you consider "mass producing" some for those poor souls like me who live in the outside world and can't afford Scubatools' shipping policy? We'd gladly pay for all costs.

I think NZ Post is still state owned and charges a couple of bucks for light items.

 

[Packhorse]

It's fully documented here, with drawings, just 1 post below yours

Thanks
Just goes to prove its easier to ask some one else to find the info than have to find it myself!!!
At this stage I was only planning on making up one but if there are others interested let me know. Could also make up others too if specs can be provided.

 

[Packhorse]

OK, I have made up a MK20/25 tool and a piston bullet for a MK20/25 too. Im assuming its the same for the MK5,10,15 but would appreciate confirmation.

After looking at a MK10 manual ( and using my memory from last time I serviced one) im not so sure a tool is really required. Perhaps I should make a 10/15 tool instead. But Im guessing the MK15 does not have a bush like the 20/25 does?? So perhaps no real need??

I have a tool that's for the MK15, and supposedly one side of it is useful for installing the HP o-ring on MK10s. I've never used it for that. If nobody comes forward with the actual MK10 tool, I can give you measurements of the one I have.

If you could that would be grand!