SaltyFrog
Contributor
How much room should it leave?
So I already printed this (attached) out and cut the 80 and 90 holes.
bare hands, thumb bent testing:
For 80mm: my hand can not pass through unobstructed. I can still squeeze it through. But it's touching the sides and is pretty "snug".
For 90mm: can pass through freely, with visible, but not big, gap on the side.
For diving conditions:
Will use latex seal and I don't usually wear any gloves.
But I do want to maintain the ability to wear the kubi dry gloves, which has a liner.
Does this mean I should get the 90?
Thanks!
So I already printed this (attached) out and cut the 80 and 90 holes.
bare hands, thumb bent testing:
For 80mm: my hand can not pass through unobstructed. I can still squeeze it through. But it's touching the sides and is pretty "snug".
For 90mm: can pass through freely, with visible, but not big, gap on the side.
For diving conditions:
Will use latex seal and I don't usually wear any gloves.
But I do want to maintain the ability to wear the kubi dry gloves, which has a liner.
Does this mean I should get the 90?
Thanks!