Good morning,
On one of my recent dives I set gas #1 at 25% and gas #2 at 32% as we were finishing up the last dive for DSAT Tec 40. At 25 minutes into the dive we switched to the stage bottles and I switched to gas #2 (32%). I confirmed and my buddy confirmed (along with an instructor) that all computers were switched over to the correct gas that we were breathing.
However, when I downloaded the profile into PCLogBook v4.0 and DiveLogBook V1.11, it only shows as being on 25% the entire time. Since the computer did not hit deco mode, is the reason the software is not registering both gases. I was about 3 minutes from entering Deco, however, my buddy is like a vacuum cleaner at depth and we needed to start our ascent. I was at a max depth of 108 with a SF of 0.
Any help is greatly appreciated, really need these deco dives t be downloaded.
Thanks
On one of my recent dives I set gas #1 at 25% and gas #2 at 32% as we were finishing up the last dive for DSAT Tec 40. At 25 minutes into the dive we switched to the stage bottles and I switched to gas #2 (32%). I confirmed and my buddy confirmed (along with an instructor) that all computers were switched over to the correct gas that we were breathing.
However, when I downloaded the profile into PCLogBook v4.0 and DiveLogBook V1.11, it only shows as being on 25% the entire time. Since the computer did not hit deco mode, is the reason the software is not registering both gases. I was about 3 minutes from entering Deco, however, my buddy is like a vacuum cleaner at depth and we needed to start our ascent. I was at a max depth of 108 with a SF of 0.
Any help is greatly appreciated, really need these deco dives t be downloaded.
Thanks
