How to deburr the middle of a threaded rod?

Please register or login

Welcome to ScubaBoard, the world's largest scuba diving community. Registration is not required to read the forums, but we encourage you to join. Joining has its benefits and enables you to participate in the discussions.

Benefits of registering include

  • Ability to post and comment on topics and discussions.
  • A Free photo gallery to share your dive photos with the world.
  • You can make this box go away

Joining is quick and easy. Log in or Register now!

Just cut the rod and replace it
Thank you.
Someone else who sees trying to save this as a bad idea. I still go with 2 wrenches and twist it in half, same outcome. Just don't have to worry about nicking a cylinder while doing the cutting. Those stainless bolts are pretty soft.
 
Thank you.
Someone else who sees trying to save this as a bad idea. I still go with 2 wrenches and twist it in half, same outcome. Just don't have to worry about nicking a cylinder while doing the cutting. Those stainless bolts are pretty soft.
Usually with rod you just take off the acorn nut on the backside and pull it out. Smaller diameter tanks its not hard to get in there and cut it. I agree on the 8" diameter tanks its probably not a good idea to cut it since there's so little gap between them
 

Back
Top Bottom