Hey everyone
I’m new here, although I’ve been lurking for a while.
I have a Daystate Type 2 compressor, which is a Coltri MCH-6 Compact, but not as wide - there’s just little space between the motor and the side of the cage. Made by Coltri, but with Daystate’s branding on the cage. I’ve attached a picture.
I would like to connect hoses to the bleed valves on the condensation tower and filter tower, so that when I purge, I can direct the spray and avoid the mess.
Has anyone done this?
Will it cause any problems?
If you have done it, what size (inner diameter) hose do I need and of what material, so that it stays on the valve?
I’m not a diver, however after everything I’ve been reading and watching, I really want to start - likely when we get out of this Covid mess.
Thanks in advance!
I’m new here, although I’ve been lurking for a while.
I have a Daystate Type 2 compressor, which is a Coltri MCH-6 Compact, but not as wide - there’s just little space between the motor and the side of the cage. Made by Coltri, but with Daystate’s branding on the cage. I’ve attached a picture.
I would like to connect hoses to the bleed valves on the condensation tower and filter tower, so that when I purge, I can direct the spray and avoid the mess.
Has anyone done this?
Will it cause any problems?
If you have done it, what size (inner diameter) hose do I need and of what material, so that it stays on the valve?
I’m not a diver, however after everything I’ve been reading and watching, I really want to start - likely when we get out of this Covid mess.
Thanks in advance!