1. A

    My Metal Workshop

    CCR manual valve project This is a small project since there's not much to do recently, waiting for COVID to end so we can travel again... I serviced my CCR manual valves (MV) and found that it had leaked water inside. After further investigation, the leak was due to low tolerances, wrong...
  2. O

    Coltri MCH-6 water drainage hose

    Hey everyone I’m new here, although I’ve been lurking for a while. I have a Daystate Type 2 compressor, which is a Coltri MCH-6 Compact, but not as wide - there’s just little space between the motor and the side of the cage. Made by Coltri, but with Daystate’s branding on the cage. I’ve...
Top Bottom