A note to Non-Tech divers w/Edge Epic (D2) 1st stages:

[divad]

You'll need a 6 mm hex head to remove the balance plug so you can ascertain whether or not you'll need the the old (looks like Zeagle) Epic or newer ( looks like Apeks) D2 rebuild kit, if you have the latter. So far that's the extent of the secret lore I've discovered. Inside the regulator looks clean and sweet.

 

[chrpai]

You'll also need 6mm hex to tighten down the DIN retainer if it ever comes loose. 80 inch lbs will do.

 

[divad]

I'm assuming from this picture

Edge Gear

that the old Epic utilized a replaceable (white) seat/oriface like a Zeagle.

---------- Post added March 30th, 2013 at 08:44 AM ----------



---------- Post added March 30th, 2013 at 07:51 PM ----------

OK, that's been verified.