XS Scuba Manifold Isolator Barrel Oring size

[redrover31]

Hello

If anyone has already been through this with an XS Scuba Isolation Pro Manifold.

Generally I've used 012 on the barrel orings with diverite, Scubapro, etc. Does the XS Scuba valve use the same size? What I removed looked slightly larger, like it could be a metric size.

Any input appreciated if you've gone through this recently with this particular manifold.

Ideally I'm just looking to replace these orings, rather than source a factory service kit.

 

[rjack321]

It's the same one used on the Thermo crossbars (and HP ports in your 1st stage), they are size 012

XS scuba part VP25-V
https://static1.squarespace.com/sta...224651556/XS-Scuba-Modular-Crossbar-Valve.pdf

Thermo part VP25-V
https://static1.squarespace.com/sta...rmo-Modular-Crossbar-H-Adapters-PRO-Valve.pdf

The used one is stretched out I suspect.

You can get them in a 100 pack at Macmaster Carr for cheap
McMaster-Carr

 

[redrover31]

Thank you, appreciate the info!

You would by chance happen to know the size of the Bonnet oring VX17-E in the diagram?

Generally they are 015, but these look to be quite a bit thicker in diameter.

It's the same one used on the Thermo crossbars (and HP ports in your 1st stage), they are size 012

XS scuba part VP25-V
https://static1.squarespace.com/sta...224651556/XS-Scuba-Modular-Crossbar-Valve.pdf

Thermo part VP25-V
https://static1.squarespace.com/sta...rmo-Modular-Crossbar-H-Adapters-PRO-Valve.pdf

The used one is stretched out I suspect.

You can get them in a 100 pack at Macmaster Carr for cheap
McMaster-Carr