Wanted WTB: 7/8"-16 UNF doubles manifold

[mahjong]

FYI: This is for a set of 3500psi, 120cuft PST tanks. I'm ideally looking for Dive Rite, so lower-profile valves than are available on the Thermo version. Please PM me if you have a serviceable 7/8" Dive Rite manifold that you'd like to sell. Thank you!

 

[guruboy]

I think OMS might be your best bet if you don't like thermo. not sure there is a DR 7/8 manifold

 

[mahjong]

I own one DR 7/8 manifold and am looking for another one. The only OMS manifolds I've ever seen are 'nipple-nut' design that I don't like. Prefer captured O-ring design.

 

[guruboy]

OMS made manifolds like this

Old OMS manifold still considered "safe"

Hi All, When I picked up a bunch of gear over the summer one item I got was a 300 bar OMS manifold like the one pictured below. I was after some HP120s and this was thrown in as part of the deal. I noticed that it uses a single o-ring and setup as a face seal for the isolator between the two...

scubaboard.com