Which glue for dump valve disk

[ngarrache]

Hello,
Does someone knows what’s the « glue » used on dump valve disk ?

 

[grantctobin]

Hello,
Does someone knows what’s the « glue » used on dump valve disk ?

On a drysuit? Ideally none. Unfortunately, DUI glues theirs.

 

[ngarrache]

Thanks but I’m thinking about the dump valve of bcd and wings…
When replacing the cord, the disk should be sealed again.
Here a picture of the disk I’m talking about.

 

[emoreira]

I use a very bad glue, as it just needs to be kept in place and be able to remove the disk when the cord breaks.
Do not use cyanoacrilate or acetone based adhesives. Unfortunatelly the brand I use is only local.

 

[Snusmumrik]

any common rubber adhesive would be enough. IMHO.

 

[Marie13]

I don’t glue mine at all on my Dive Rite wing. You just use something to pry the rubber disk out and then you just pop it back into place. Mine wasn’t glued from the manufacturer.

Was yours glued?

 

[Gone for diving]

Use silicone or something like that, it can be peeled off easy after...
Even crazyglue would be fine. But will not come off the rubber as easy...

 

[ngarrache]

I don’t glue mine at all on my Dive Rite wing. You just use something to pry the rubber disk out and then you just pop it back into place. Mine wasn’t glued from the manufacturer.

Was yours glued?

I didn't pulled out yet on my wing but on my bcd it was glued...

 

[ngarrache]

I start thinking about using aquasure...

 

[Dsix36]

I use 3M weatherstrip adhesive.