Sandy Dameron
Registered
Trying to figure out what went wrong.
First day of diving in Cozumel, on a 3 dive day, 1min into 3'rd dive, VT4.0 DC went into DECO mode - Yikes!
After downloading dive log detail into OceanLog (ver 2.3.7) I can see my Tissue Load Bar Graph segments were not receeding after each surface interval. 1 min into 3'rd dive TLBG segment crossed to '5', which started the DECO state.
Surface interval between dives 1 & 2: 4 hrs.
Surface interval between dives 2 & 3: 35 min.
I had to reset the DC to clear VIOLATION for following days. Never had the problem again during the remaining days of the trip. Looking at dive log detail for other days the TLBG did receed after each dive and surface interval. For example, the second day, after the first dive, TLBG was 3, then after :51 min surface interval it was down to 1.
I've uploaded a spreadsheet with the first two days of dive detail where you can see the detail.
Any insights on what may have happened would be appreciated.
Thanks!
Sandy
First day of diving in Cozumel, on a 3 dive day, 1min into 3'rd dive, VT4.0 DC went into DECO mode - Yikes!
After downloading dive log detail into OceanLog (ver 2.3.7) I can see my Tissue Load Bar Graph segments were not receeding after each surface interval. 1 min into 3'rd dive TLBG segment crossed to '5', which started the DECO state.
Surface interval between dives 1 & 2: 4 hrs.
Surface interval between dives 2 & 3: 35 min.
I had to reset the DC to clear VIOLATION for following days. Never had the problem again during the remaining days of the trip. Looking at dive log detail for other days the TLBG did receed after each dive and surface interval. For example, the second day, after the first dive, TLBG was 3, then after :51 min surface interval it was down to 1.
I've uploaded a spreadsheet with the first two days of dive detail where you can see the detail.
Any insights on what may have happened would be appreciated.
Thanks!
Sandy