Timmyjane
Contributor
I was working on designing a piston o ring bullet today and they have a really small base. 4.3mm. I was using a 10mm brim at .1mm thick.
Looking at the brim after taking it off the bullet I thought it looked a lot like the shims that were in the regulator. Thickness seemed awful close. Would it be reasonable to think you could use ABS or Nylon or ASA to print the shims used in the regulators to set the pressure?
www.thingiverse.com
Looking at the brim after taking it off the bullet I thought it looked a lot like the shims that were in the regulator. Thickness seemed awful close. Would it be reasonable to think you could use ABS or Nylon or ASA to print the shims used in the regulators to set the pressure?

Scubapro Piston Bullet O Ring Assembly Tool by timmyjane
Tool to assemble Scubapro balanced piston regulators such as MK5, MK7, MK10 and others. Keeps the knife edge of the piston from cutting or damaging internal o ring when installing the piston.
