Scubapro BCD Part ...

[emoreira]

This is an old Scubapro inflator elbow.
No o-ring.

 

[johndiver999]

that is a more modern one than the op has, I think

 

[MR12111]

My exact BCD and took it to the ScubaPro dealer in Sarasota. He called to let me know Scubapro no longer has a source for that gasket. It was a flat silicone washer but no longer avaliable. He suggested using silicone rubber like used as a sealant in the automotive industry. I suppose as when it is tight it can't rotate anyway but going to ace hardware and looking for a thin flat rubber washer 1st. if not I will probably try his idea as the joint on the shoulder does not rotate. Any one have any other thoughts. If I didn't know better this bcd otherwise could pass for never used.

Thanks for the reply ..someone in this thread had the same BC and took it apart for me so he could advise me ... it takes a standard oring ..don't ask what size ..but it goes on the other side of the connection from what I thought .. As soon as he showed me It was easy to fix ..5 dives on that BC since then ... Thanks for you help ..

 

[MR12111]

This is an old Scubapro inflator elbow.
No o-ring.

Thanks ..got it fixed ..someone else had the same bc and took it apart ...mine uses an oring ..fixed now and 5 dives on it

 

[MR12111]

that is a more modern one than the op has, I think

Thanks ..got it fixed ..someone in this forum has the same bc took it apart and showed me where the oring goes ..I have 5 dives on my "vintage" new old stock BCD ...

 

[happy-diver]

So what about an oring size to educate all those contributors that don't know and can't see and a photo