Runnaway foam

[wetman]

What do you people do with the foam in pelican cases once its been plucked? My issue is that i have some fancy designs plucked out of it for my gear, but pully the gear out sometimes will pull some of the fancier sections out with it and i have to plop it back in place. What would be the best glue for the job - i'd think there would end up being some moisture in the case at points so it would have to tolerate that and it would also have to be able to adhere to the foam.

thanks

steve

 

[Padipro]

I made a two layer foam cut out for my computer and the top layer would always come out with computer so I used some of that spray contact cement. I could remove everything from the case and seperate the layers so there was no chance of any over spray messing things up so I'm not sure it would work as well for you. I still think some brush on contact cement would work though.

Scott