Revo RMS fault finding (which probe has failed)

[Heat Miser]

@Wibble

On the Scrubber page it only shows the durations in hh:mm. I've not seen a "temperature page".

You have shown me plenty of stuff, so its nice to me able to repay the favour ... I know the function works with Petrel 2 and Petrel 3's ( maybe upgrade your computer / software)


Regards

 

[sprockjohnson]

My rEvo is non-RMS so I can't say for certain that this would be the way to identify but if you have already ordered a new probe then just check the resistance of the new probe in ambient temperature and then check the probe on each cassette, also in ambient temperature, to see which reads the same/ similar to the new probe.

 

[Wibble]

My rEvo is non-RMS so I can't say for certain that this would be the way to identify but if you have already ordered a new probe then just check the resistance of the new probe in ambient temperature and then check the probe on each cassette, also in ambient temperature, to see which reads the same/ similar to the new probe.

The clever thing about the RMS probes is they're sealed and have no cables. Think there's some form of induction interface.

 

[Wibble]

@Wibble



You have shown me plenty of stuff, so its nice to me able to repay the favour ... I know the function works with Petrel 2 and Petrel 3's ( maybe upgrade your computer / software)


Regards

Thanks

The vid's come up as set to private.

 

[Heat Miser]

Thanks

The vid's come up as set to private.

I think I fixed it

 

[Wibble]

Wow — never knew that. Thanks!