yungjeezle
Registered
- Messages
- 41
- Reaction score
- 0
i'm not sure if this is the right forum, but are there instructions on how to put all the unit all together?
putting it all together
- Thread starter yungjeezle
- Start date
Please register or login
Welcome to ScubaBoard, the world's largest scuba diving community. Registration is not required to read the forums, but we encourage you to join. Joining has its benefits and enables you to participate in the discussions.
Benefits of registering include
- Ability to post and comment on topics and discussions.
- A Free photo gallery to share your dive photos with the world.
- You can make this box go away
What unit are you referring to?
OP
yungjeezle
Registered
- Messages
- 41
- Reaction score
- 0
putting the octopus, gauges, etc. onto the first stage
Well, I am not sure what regulator you have but, what I do after I service a regulator is to hold the first stage out in front of me with the yoke knob closest to me. I then take the first LP port closest to the top on the right side as it sits in front of you and attach your primary second stage. The next LP port below that is where you would connect the octo hose. You would then go to the LP port closest to the top on the left hand side and connect the LP inflator hose (with the qd that goes to your bcd. The SPG console or computer would then be connected to the HP port on the right up on the regulator body. That is what you would do for the basic reg setup but, hard to say for sure if what you have is unknown. Hope that helps.
Similar threads
