Aqua-Andy
Contributor
I just finished rebuilding one of my D1 cold regs and noticed some corrosion on the DIN housing P/N C-01-002-14
. It has been around 18 months since the last overhaul(done at the HOG repair clinic) and there was no corrosion that could not be cleaned off at that time. this is in a spot where there is no seal and water can get to it. After every salt water dive I soak my regs pressurized for at least an hour and let air dry. Around 80% of my diving is in salt water. Is there anything other than servicing the regs more often that would prevent this kind of corrosion? It is not on a sealing surface so it will not affect the operation of the reg but I still don't like it.