J-Vo
Contributor
As in you put the glove where the wrist seal should be (make it permanent sort of) or you just remove the wrist seal and use only the pull over gloves?
Remove the seal and put the glove in the lock ring.
Welcome to ScubaBoard, the world's largest scuba diving community. Registration is not required to read the forums, but we encourage you to join. Joining has its benefits and enables you to participate in the discussions.
Benefits of registering include
As in you put the glove where the wrist seal should be (make it permanent sort of) or you just remove the wrist seal and use only the pull over gloves?
My experience has been with the Aqualung/White's Bullet drysuit and the Sitech Glove Lock QCP system. It has been easy to use and setup. However the rings are big and does limit mobility of the wrist if not set up properly. This system also allows for replacement of the seals and gloves without special tools.
My experience has been with the Aqualung/White's Bullet drysuit and the Sitech Glove Lock QCP system. It has been easy to use and setup. However the rings are big and does limit mobility of the wrist if not set up properly. This system also allows for replacement of the seals and gloves without special tools.
Would the Fourth Element Ellipse system also work with the Aqualung SLT cuffs? Seems like it...