DepthCharge
Contributor
Trying to rebuild Omega 2 Trying to remove control valve screw. According to manual it takes a 1/4 in socket. Not happening, too big. Tried 7 mm, hits flats but not enough to remove valve. Any suggestions?
oceanic Omega 2 service
- Thread starter DepthCharge
- Start date
Please register or login
Welcome to ScubaBoard, the world's largest scuba diving community. Registration is not required to read the forums, but we encourage you to join. Joining has its benefits and enables you to participate in the discussions.
Benefits of registering include
- Ability to post and comment on topics and discussions.
- A Free photo gallery to share your dive photos with the world.
- You can make this box go away
Tanks A Lot
Contributor
When you say the 1/4" socket is too big, do you mean it is too big for the actual hex on the screw?
I remember that the hex on this screw is situated very low on the screw and required a very deep walled socket to reach at all. Unfortunately I can't remember what size it is, but for what it's worth, all manuals I have mention a 1/4" socket, but also specify a deep walled one.
I remember that the hex on this screw is situated very low on the screw and required a very deep walled socket to reach at all. Unfortunately I can't remember what size it is, but for what it's worth, all manuals I have mention a 1/4" socket, but also specify a deep walled one.
Similar threads
