oxyhacker
Guest
- Messages
- 1,314
- Reaction score
- 36
There's a picture, not very big unfortunately, in the GALLERY on our website, at the link below. Most sensors will screw into a 3/8" NPT hole even though they aren't really threaded NPT, however it is much easier to use the little O-ring sealed "flow diverter" that comes with the teledyne ones, and fits into a 9/16" hole. The Oxy Hacker stick has a PVC tee at the bottom, and the sensor goes into one of the ports which has been bushed and drilled out to take the flow diverter, but there's a barbed plastic tee you'll find in most hardware stores that will perfectly fit the diverter without any modification.
Not rocket science - take you sensor and adaptor to the hardware store and you'l find many fits.
Not rocket science - take you sensor and adaptor to the hardware store and you'l find many fits.
pensacola:Can someone post a picture of the setup that you have for the sensor at the bottom of the stick (prior to compression/detonation)? Thanks