lynchpit2
New
I got this thinking I would make it a project but just won't have the time.
It is a Mako K51 5.1cfm compressor with a 5hp 3 phase motor. I also don't have 3 phase so that kind of sealed the deal for not tinkering with it.
It does not have a control box or plug to the unit so I have not been able to run it.
It also does not have any whips or fill hoses.
I did test the motor and all 3 legs of the cable come back with the same resistance on an Ohm test.
It also does not have any bleed when going from each leg to ground.
Near as I can tell this is not missing any parts integral to the compressor itself.
PM me with any questions or offers and I will answer them the best I can.
Asking $500 plus you arrange shipping.
It is a Mako K51 5.1cfm compressor with a 5hp 3 phase motor. I also don't have 3 phase so that kind of sealed the deal for not tinkering with it.
It does not have a control box or plug to the unit so I have not been able to run it.
It also does not have any whips or fill hoses.
I did test the motor and all 3 legs of the cable come back with the same resistance on an Ohm test.
It also does not have any bleed when going from each leg to ground.
Near as I can tell this is not missing any parts integral to the compressor itself.
PM me with any questions or offers and I will answer them the best I can.
Asking $500 plus you arrange shipping.
