Making fin straps easier to remove

Please register or login

Welcome to ScubaBoard, the world's largest scuba diving community. Registration is not required to read the forums, but we encourage you to join. Joining has its benefits and enables you to participate in the discussions.

Benefits of registering include

  • Ability to post and comment on topics and discussions.
  • A Free photo gallery to share your dive photos with the world.
  • You can make this box go away

Joining is quick and easy. Log in or Register now!

I would sew it but webbing seems pretty hard to sew
Soft webbing such as this is pretty easy to sew. You could even hand tack it with outdoor rated nylon thread and a large needle from your local fabric store. But the average sewing machine could handle it too.

Its the resin impregnated webbing like the typical dive harness that is a bear to stitch.
 
aluminum rivits work too.
 
Take it to your local shoemaker. About 5 quid should seal the deal.
 
I was suggesting sewing the soft webbing. I agree the stiff stuff might put blisters on your sewing fingers.
 
I use a simpler solution:

_20190212_155056.JPG
 
Those Italians... :shakehead: 69 Euros. That’s more than the cost of some of the fins that they go on. :)

I just have standard springs. I reach down and pull them on and off pretty easily. I haven’t ever had any sort of loop system so I guess I haven’t gotten spoiled by other systems.
 

Back
Top Bottom