TN Traveler
Contributor
Just got back my regulator that was repaired due to a bad HP seat.
Unfortunatley I am headed out for a dive trip next week and do to weather, will not be able to test them in the quarry or a pool before leaving.
I was hoping one of the Technicians here could advise me on the best way to be sure there is no IP Creep, prior to my leaving. Don't want a freeflow during my trip and then have to rent equipment.
I have an IP Gauge - but not sure if just leaving it on for an hour or two on a full tank is sufficient testing or if I should breath off the reg several times during the time it is under pressure?
Thanks in advance for your input
Unfortunatley I am headed out for a dive trip next week and do to weather, will not be able to test them in the quarry or a pool before leaving.
I was hoping one of the Technicians here could advise me on the best way to be sure there is no IP Creep, prior to my leaving. Don't want a freeflow during my trip and then have to rent equipment.
I have an IP Gauge - but not sure if just leaving it on for an hour or two on a full tank is sufficient testing or if I should breath off the reg several times during the time it is under pressure?
Thanks in advance for your input