Installing Power Inflator on my Halcyon BP/W

[Soggy]

I used plain old elementary school Rubber Cement to hold it on. Works well and it's removable. I also used two zip-ties in opposite directions.

 

[Dan Gibson]

I was just too lazy last night to go and get the measurements. If I can remember, I will try and measure the old inflator versus the new one sometime this weekend.

I only have the new ones since I got mine exchanged but using electronic calipers on one of them, I get .990" / 25.15mm. (Above the retaining flange, of course.)

 

[Dan Gibson]

My old 18# wing finally died so I salvaged all the parts off it. The diameter above the flange measured about 1.020". Probably not a significant enough difference. It could be that replacing an old inflator with a new one resulted in a stretched out corrugated hose.

I only have the new ones since I got mine exchanged but using electronic calipers on one of them, I get .990" / 25.15mm. (Above the retaining flange, of course.)