floridafrogman
Guest
I posted this question on the "Basic Scuba Discussions" page
(see Jan. 31, 2003) but probably should have posted it here. I'm new to this forum and did not see a method of transfering or
copying a message from one catagory to another, so forgive the
duplication.
If anyone knows the common low pressure port thread size (and
pitch) for an Italian manufactured reg., please advise. This is for
a Reg. marketed in Europe, as opposed to, a Reg. made overseas
with the intention of selling in the USA (i.e., . Mares, Cressi, SporaSub, etc.) which have 3/8" x 24 O-ring thread.
Most Reg.'s made for Euro distribution have metric ports, that's what I'm trying to identify.
Thanks, Rick
(see Jan. 31, 2003) but probably should have posted it here. I'm new to this forum and did not see a method of transfering or
copying a message from one catagory to another, so forgive the
duplication.
If anyone knows the common low pressure port thread size (and
pitch) for an Italian manufactured reg., please advise. This is for
a Reg. marketed in Europe, as opposed to, a Reg. made overseas
with the intention of selling in the USA (i.e., . Mares, Cressi, SporaSub, etc.) which have 3/8" x 24 O-ring thread.
Most Reg.'s made for Euro distribution have metric ports, that's what I'm trying to identify.
Thanks, Rick