Does anybody know the diameter of a meg?

[Mverick]

Looking to see if anybody knows the diameter of the meg cannister. Inner and outer. But just outer would be fine. Also, The total height and height of the cannister.

Thanks, Rick

 

[ussmeg]

Its 18" to top of lid, about 17.75 without lid on, 19.25 to top of handle/O2 elbow.
7" Dia and 6.5 inside Dia. Hope this helps?
Paul

 

[Mverick]

Its 18" to top of lid, about 17.75 without lid on, 19.25 to top of handle/O2 elbow.
7" Dia and 6.5 inside Dia. Hope this helps?
Paul

Thanks,

Am home building one. And would like to be able to use the scrubber they come out with later. Was going to use Titanium. But, Then I remembered O2 and titanium don't mix. Would worry a little about a hot scrubber on it....

 

[ussmeg]

Thanks,

Am home building one.

Save yourself the time and just write the check, It will be easier & cheaper in the long run.

Paul

 

[Hootis]

Yep....I second that. Somehow the DIY gig never works out. Write the check.

Ryan

 

[SamDiver14]

Yep....I second that. Somehow the DIY gig never works out. Write the check.

Ryan

Nonsense, without the DIY guys we would have never had SCUBA at all. True it doesn't always work the first time, but it can be perfected over time and perhaps eventually turn into something better than the factory original.

But to be fair, if the goal is to get in the water to dive then write the check.