conshelf 21 intermediate pressure ?

[idive2]

I've located online pdf files for the conshelf XI and the Conshelf XIV but unable to find
anything on the Conshelf 21. It looks very close to the XIV and was wondering if the
IP pressures are similar. The IP pressures in the conshelf line seem to run from 110 psi
shown for the Conshelf XI as high as 140 psi shown for the conshelf XIV. As long as the second
stage is adjusted after the first stage just wondering if plus or minus 10 psi or so from the
first stage is of any concern. I will be using a conshelf 21 first stage with a conshelf XI second stage.
I'm seeing 120-140 psi as a general intermediate pressure range on most regulators.

 

[Fishpie]

As you said 120 to 140 is fine.
I normally adjust to the upper end of the scale for warm water and lower for cold.

 

[herman]

I set everything I have at 135, makes swapping around stages less of an issue and I don't have to keep up with what reg was set to what.

 

[Mitchell Teeters]

I was diving the XXI with matching seconds. You are fine.


Sent from my iPad using Tapatalk

 

[Paladin]

All my Connies are set at 140 psi.