Compressor inventory restored

[frogman62]

All,
I have been so busy in the last 4 weeks my web site has not been updated.

I now have compressors available without any waiting time. All units Now have full commercial moisture traps and filters for up to 5000PSI continuous operation.

The smallest is a 2.4 CFM unit with kidde compressors driven with a 2 HP electric motor 115 or 230 volt with manual moisture drain. Unit can be operated for 3-4 hours run time with out being shut off. Fill time for a standard 80 cuft cylinder is 33 minutes ( 0 to 3200PSI)

Mid size is a 4.2 cfm unit with Kidde compressors driven with 3 HP electric motor OR a 6.5 HP gas engine. Commercial moisture traps and filters allow for up to 5000PSI continuous operation. Will supply a small dive shop with 50-75 fills / week with a 3 tank (330 cuft) storage system. Fill time for a standard 80 cu ft tank is 19 minutes (0 to 3200PSI)

Largest size is a 6.0 CFM Noah Howden (Kidde) unit driven with a 5 HP electric OR a 9 HP (must be special ordered) gas engine. FIll time for a standard 80 cuft cylinder is 14 minutes. (0 to 3200PSI). With 5000PSI capacity and continuous operation this will supply a dive shop requiring 60-100 tank fill / week

All three size compressors are capable of handling a nitrox stick with up to 39% Oxygen mix.

Jim Shelden
sheldensportinggoods.com
316-992-0505

 

[itsjustme0770]

Jim,
What are you charging for your midnsized compressor? Fob?

 

[frogman62]

The midsize 4.2 CFM gas or electric is $2985 plus shipping. comes with a fill whip (4 ft line ,line valve, 7500PSI pressure gauge, bleed valve and either a yoke or DIN valve connector) Filter installed is for grade E breathing air ( Lawrence Factor cartridge X65240)
Jim Shelden
316-992-0505
sheldensportinggoods.com

 

[robendeb]

Hi Jim,

I´m currently looking for a compressor that fills 2 tanks at the time in about 15 mins. I have no knowledge of compressors, but ideally it must run on 110V, but 220V is also OK. preferably not diesel or gasoline fueled.
I might be in a situation I need to fill about 6 / 10 tanks a day (12 ltrs) upto 3200 PSI/200BAR
What kind of compressor do you recommend? Shipment should be to Miami to be forwarded to Panama.

Thank you for your help.