GLOBALflyer
Registered
- Messages
- 18
- Reaction score
- 0
-
ATX50 Assembly
- Thread starter GLOBALflyer
- Start date
Please register or login
Welcome to ScubaBoard, the world's largest scuba diving community. Registration is not required to read the forums, but we encourage you to join. Joining has its benefits and enables you to participate in the discussions.
Benefits of registering include
- Ability to post and comment on topics and discussions.
- A Free photo gallery to share your dive photos with the world.
- You can make this box go away
R
redacted
Guest
Just enough torque so that you can't undo the connections by hand. The o-rings make the seal. Scubapro spec is 80 inch pounds. Best to lube the o-rings with a bit of O2 compatible lube like christolube. But I don't think I would worry about it if you can't get some.
Find a new LDS that does not turn down an opportunity to make an honest buck just so they can punish a potential customer who had the audacity to shop elsewhere.
Find a new LDS that does not turn down an opportunity to make an honest buck just so they can punish a potential customer who had the audacity to shop elsewhere.
Just screw them in hand tight, take a wrench and tighten a LITTLE BIT more. They all have an O-ring, so they don't have to be very tight at all. A little "food-grade silicone" (spelling) on the oring is ok, but that's all you need. No thread tape or anything like that.
GREAT REG
GREAT REG
Similar threads
